TRANSMISSION GASKETS & SEALS for Type II Bus Single Cab 1966

Items: 118 of 18
    • 8% less

    This transmission gasket set has everything you will need to overhaul your swing axle or type 1 transmission.

    Beetle Type 1: 61-79
    Bus Type 2: 61-67
    Ghia: 61-74

    • $17.99
    • 8% less

    Kit includes all the gaskets and O-rings required to assemble a Type 2 Bus 002 style standard transmission. These gasket sets are manufactured by an O.E. supplier. Each gasket is cut from material of the same type and thickness as original. Note- the drive flange and cup seals are not included. FITS: Bus 1968 to 1975

    Bus Tyle 2: 68-75
    Transmission Type: Bus 002

    • $13.99
    • 8% less

    Replacement mainshaft seal on both irs and swing axle VW transmissions. Insures against gear oil leaking into the bellhousing and wrecking your clutch

    Beetle Type 1: 46-79
    Bus Type 2: 50-79
    Ghia: 56-74

    • $3.99
    • 8% less

    PREMIUM VERSION

    Replacement mainshaft seal on both irs and swing axle VW transmissions. Insures against gear oil leaking into the bellhousing and wrecking your clutch

    Beetle Type 1: 46-79
    Bus Type 2: 50-79
    Ghia: 56-74

    • $9.99
    • 8% less

    These are the seals that tap into the drive flanges on type 1 vw IRS transmissions. Behind these seals is the snap ring to hold the drive flange to the output shaft on the transmission. Over time these can become dislodged or begin leaving. They are pressed in and should be replaced whenever you have a CV joint off

    Beetle Type 1: 68-79
    Ghia: 69-74
    Type 3: 69-74

    • $6.99
    • 8% less

    Axle tube gaskets are used on vw swing axle transmissions between the case and the 6 bolt flange that holds the axle tube on. These are also considered shims to help adjust the axle tube. You will need to start with 6 shims and remove 1 at a time until the axle has a steady but controlled drop.

    • $1.99
    • 8% less

    These special urethane seals fit right into the cv joint flanges to prevent the axles from beating the transmissions. Tough urethane will not tear or flatten like stock seals. For use with T1 to T2 conversion drive flanges and T1 stock drive flanges. Sold in pairs

    • $12.99
    • 8% less

    Final drive seals for irs transmissions. These seal around the drive flangles on the side of a irs transmission.

    36mm ID x 60mm OD x 15mm Thick

    Beetle Type 1: 69-79
    ghia: 69-74

    • $8.99
    • 8% less

    These special urethane seals fit right into the CV joint flanges to prevent the axles from beating the transmissions. Tough urethane will not tear or flatten like stock seals. Sold in pairs

    • $12.99
    • 8% less

    REPLACEMENT SIDE COVER SEAL FOR inches 002 inches TYPE 2 BUS TRANSMISSION. CHECK YOUR SEAL MEASURMENTS, SOME EARLY 3 RIB TRANSMISSIONS USE A DIFFERENT SEAL NOT AVAILABLE TO US.
    42MM X 67MM X 17 6MM

    Bus Type 2: 68-75
    Transmission Type: Type 2 002

    • $7.99
    • 8% less

    Replacement seal for the final drive on all inches 091 inches 6 rib transmission. This is the seal that goes into the side cover and seals around the splined stub that comes out from the ring and pinion. It is behind the CV Flange.

    Dimensions:
    45mm x 72mm x 15mm

    Transmission: 091 VW Bus
    Vanagon: 80-92
    Bus Type 2: 76-79

    • $8.99
    • 8% less

    Replacement nose cone seal. Presses into the brass housing at the end of your nose cone on type 1 applications

    Beetle: All years
    Transmission Type: All Type 1

    • $2.99
    • 8% less

    Type 2 replacement drive flange plug, fits 69-79

    Bus Type 2: 68-79
    Vanagon: 80-92
    Transmission Type: Bus 002.

    • $3.99
    • 8% less

    These strong metal main bearing thrust plates eliminate movement of main shaft bearings. Aids in maintaining the alignment of the gears on the pain and pinion shafts to give the gears FULL contact thereby reducing the changes of failure

    Transmission Type: Type 1 All
    Material: Steel

    • $25.99
    • 8% less

    This hardened steel shift ball replaces the factory plastic unit which when subjected to any abuse will usually fail. Precision built to slip right in to your Type 2 IRS.

    • $19.99
    • 8% less

    These strong metal main bearing thrust plates eliminate movement of main shaft bearings. Aids in maintaining the alignment of the gears on the pain and pinion shafts to give the gears FULL contact thereby reducing the changes of failure

    Transmission Type: Type 2 All
    Material: Steel

    • $25.99
    • 8% less

    Replacement mainshaft Bearing for Type 1 and Type 2 Transmissions

    Beetle Type 1: 74-75
    Bus Type 2: 71-75

    • $29.99
    • 8% less

    Replacement mainshaft Bearing for Type 1 and Type 2 Transmissions

    Beetle Type 1: 74-75
    Bus Type 2: 71-75

    • $10.99

New arrivals