MORSE CABLE ACCESSORIES for Super Beetle Convertible 1978

Referred to as the wish bone. This stainless steel bracket is for use with all of our empi, latest rage and neal pedals. Provides a direct attachment of the throttle cable without compromising bends

8 inches cable extension that can be cut to size
Thread Size: 10/32 inches
Quantity: 1 Piece

This handy extension kit screws onto the end of our throttle cables and makes adjusting your linkage as simple as loosening a wing nut. A must for adjustable pedal sliders. Measures 8-1/2 inches and extends to 19-1/2 inches

Many carbs require changes to the throttle assembly.
This extender will increase length of the stock throttle cable approximately 1 1/2 inches kit comes with throttle extender and cable lock

3/16 inches balljoint quick release cable end most commonly used at pedal end of cable.
This attaches to our Push/Pull style cables.
Threaded end: 3/16 inches
Female End: 10/32
Quantity: Sold Each

Use this rod end to attach your morse cable up to a standard y bracket on all pedal sets
10-32 thread on the cable fits all of our sleeved push pull style cables

Clevis and pin cable end most commonly used at engine end of cable.
10-32 Threads
These fit our morse style sleaved cables. Will work with both the standard and supreme as well as the silver jacket line

Cable clamp & shim two piece bolt together clamp
Use this clamp to securely fasten your morse style cable to your chassis. You need to fasten morse style cables at both ends for them to work properly

Clip to hold your morse style cable into place. Flip over release.
Height (bottom to center of mounting): .900 inches
Hole diameter: .200 inches
Length: 1.675 inches
Width: 1 inches
Height: 1 5/16 inches
Steel hook L clamp cable mount. This mount is for locking down your push pull throttle cables so that you eliminate that partial movement in the throttle that keeps your engine open after you take your foot off. Made from heavy duty steel making this L hook clamp essential for all off-road users. Each clamp is sold separately and is easy to install.

Clevis and pin cable end. Flat.
Height (bottom to center of mounting): 2 3/8 inches
Length: 2.787 inches
Hole Diameter: .200 inches

Aluminum half clamp for cable anchoring either end.
Bolt hole diameter: .200 inches
Length: .784 inches
Width: .512 inches
Cable Hole Diameter: 3/8 inches

Kit includes chrome plated steel bracket, springs, bushings and hardware to fit a variety of applications.

Kit includes two springs and mounting bracket.

Chrome plated steel bracket provides mounting location for return spring.