STEERING SHAFT MOUNTS for Type 3 Fastback 1968

Billet steering bearing housing. 4 inch long. Clamps on 1-1/2 inches tube. Brass bushing for steering shaft. Nice easy way to setup your steering.

Mounts a 3/4 inches steering shaft

Length: 4 inches
Height: 3-1/4 inches
Width: 2-1/2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.

Heavy duty construction with brass bushing.

Fits a 3/4 inches Steering Shaft

Welding Required

Length: 5.144 inches
Width: 4.5 inches
Height: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.

Heavy duty construction with brass bushing for steering shaft.

Fits a 7/8 inches Steering Shaft.

Welding Required

Length: 5.144 inches
Width: 4.5 inches
Height: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.

Needle bearing with seal. Heavy duty construction.

Fits a 7/8 inches Steering Shaft

Welding Required

Length: 5.144
Width: 4.5
Height: 2 inches

Tilt steering assembly allows easy access to tight driver seats. Welds to 1-1/2 inches tubing. Uses a 3/4 inches steering shaft