FRONT SUSPENSION for Type 3 Notchback 1963

Chrome axle beam clamp. Replace rusted out clamps on your sand rail with these highy polished unit. Adds a clean custom look to the front of your machine.
Sold: Each

0.22
Hole Diameter: 9/16 inches
Sold: Pair

These A-arm Mounting plates are a universal design and are 6 center to center on the holes. NOTE: Check your measurments before ordering as the a-arm mounting holes may not match all aftermarket spindles. Hole Diameter: 1/2 inches Thickness: 3/8 inches Sold: Pair

This adjuster allows up to four inches of adjustment to the front end. Allowing the driver to quickly raise or lower the car depending on terrane. One adjuster will work but under extreme off road conditions it is recommended to have one in each tube

If you intend to weld tabs or tow hooks to your brackets prior to paint or powder coat then use these raw stamped brackets.
Sold: Each

This adjuster allows up to four inches of adjustment to the front end. Allowing the driver to quickly raise or lower the car depending on terrane. One adjuster will work but under extreme off road conditions it is recommended to have one in each tube

Mount a VW axle beam to a tube chassis with our HD Front End Clamps. Heavy Duty upgrade built to withstand off road punishment. Can be used to mount Baja Tube Bumpers. Made from heavy duty stamped steel. Raw finish, includes hardware.

If you plan to off-road your buggy or baja these front end beef kits will be good insurance that your front end will be together when you come back. All gussets must be welded

10 shock tower kit for use with a 10 stroke shock. Welds to stock axle beam. Welding is required. Tower Height: 15 inches from tube Thickness: 1/4 inches Quantity: 2 Pieces

Steel mounting bracket for installing a beam front end to a chassis or frame head.
Fits King Pin Front Ends
Sold Each

10 inch shock tower kit for coils. Welds to stock axle beam. Welding is required. Allows the use of coil shocks with extended travel

Brace up your king pin spindles with these special cut gussets. These weld onto the carrier to cure the flexing problem
Pack of 4