TRAILING ARM BEARINGS & SEALS for Type 3 Notchback 1972

Application year: 54,55,56,57,58,59,60,61,62,63,64,65,66,67,68...
Outer diameter: 2.834 inches
Thickness: .748 inches

This is the inner bearing on a vw IRS rear trailing arm. This is put in from the CV side. If you hear a lot of clunking or ticking, it is time to replace. These take a lot of abuse expecially in a offroad situation.
113-501-283
Type 3: 69-74

This is the outer bearing inside a vw IRS trailing arm. These take a big beating so replace them whenever you change stubs.
Inner diameter: 1.182 inches
Outer diameter: 2.440 inches
Thickness: .630 inches
Type 3: 69-74

PREMIUM VERSION
SKF BRAND
This is the outer bearing inside a vw IRS trailing arm. These take a big beating so replace them whenever you change stubs.
Type 3: 69-74

Replacement rear axle seal for all type- 1 applications. These go both on the inside of the trailing arm by the cv joint and also on the outside under the 4 bolt bearing cap.
This works on both IRS and swing axle transmssions.
Swing axles only need 1 per side but IRS will require 2
Ghia: 56-74

Replacement seal kit kit. This kit will work for both IRS and Swing Axles applications. A must if replacing bearings or installing disc brakes. Keep the oil from running into the brake drum on swing axles and keep out the dirt
Ghia: 56-74

IRS bearing housing clip to snap your bearings into place. This goes on the CV joint side of the arm and is snapped into the bearing carrier. This is often times not needed as the stub pinches the bearings into place.
Sold Each
Type 3: 69-74

This is used if you are eliminating your backing plates and using a brake kit that requires welded on mounts. Boxed trailing arms are usually used with these.
Thickness: 3/16 inches
Bolt pattern: 2 1/2 inches x 2 1/2 inches
Inner Diameter: 3.04 inches
Length: 3.938 inches
Width: 3.716 inches

Replacement outer type 2 axle seal. This seal will go next to the wheel bearing and behind the 4 bolt cap that holds either the backing plate on or caliper bracket
Vanagon: 80-82
Quantity: Sold Each.

Replacement wheel bearing for the rear of your Type 2 Bus 71-79
Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 50-67
Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 68-79
Inner
Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 63.70
Sold Each