STARTERS & BUSHINGS for Type 3 Squareback 1963

Starter for all type 1 VW engines
Electrical System: 12 Volt

PREMIUM VERSION
BOSCH
Starter for all type 1 VW engines
Electrical System: 12 Volt

30% more starting power over stock units. Completely sealed with o-rings
Electrical System: 12 Volt
Power: 1.0 kW
Gear Ratio: 4.44:1

Fits All beetles with 12 volt charging system and a 6 volt flywheel
30% more starting power over stock units. Completely sealed with o-rings
Electrical System: 6 Volt
Gear Ratio: 4.44:1

30% more starting power over stock units. Completely sealed with o-rings
Gear Ratio: 4.44:1

30% more starting power over stock units. Completely sealed with o-rings
Power: 1.2 kW
Gear Ratio: 4.44:1

30% more starting power over stock units. Completely sealed with o-rings
Finish: Raw

30% more starting power over stock units. Completely sealed with o-rings. Fits a Mendeola transmission
Power: 1.4 kW
Gear Ratio: 4.44:1

9 tooth gear package
Quantity: Kit

30% more starting power over stock units. Completely sealed with O-rings. Polished
Finish: Chrome

Replacement 12v starter bushing. A must if your start is worn out or feels like its dragging. This brass bushing pushes into the bell housing and supports the front of the starter
Beetle Type 1: 1964-1974
Size: 12 volt
Quantity: Sold Each

Starter Bushing, 6V. It is pressed into the VW Transaxle, and it supports the starter motor shaft. A worn bushing allows the starter shaft to move out of alignment, and it grounds out and will not work!
Fits all Models VW up to 1966
Voltage: 6 Volt
Material: Brass

Easy to install adapters allow mismatch of transaxle and starter. Permits 12 volt starter and flywheel to be used on 1966 and earlier transaxle

Easy to install adapters allow mismatch of transaxle and starter. Presses on shaft of 6 volt starter and allows it to be used in 1967 and later transaxles

Allows increased juice to the starter by momentarily by-passing the ignition switch.
Easy installation

30% more starting power over stock units. Completely sealed with o-rings
Gear Ratio: 4.44:1