THROW-OUT BEARINGS for Type 3 Squareback 1971
Items:
1–6 of 6
Sort by:
Recommended
-
Early model throw out bearing for vw. Early style will have removable clips that attach to small round stubs on both ends of the bearing. Check out your combination carefully before order because these can be mix matched between all years by changing the throw out bearing arm. This bearing should match a pressure plate that has a ring in the center of it.
NOTE: THESE DO NOT INCLUDE THE CLIPS
Beetle Type 1: 47-70
Bus Type 2: 56-70
Ghia: 56-70 -
Early model throw out bearing for vw. Early style will have removable clips that attach to small round stubs on both ends of the bearing. Check out your combination carefully before order because these can be mix matched between all years by changing the throw out bearing arm. This bearing should match a pressure plate that has a ring in the center of it.
Ghia: 56-70 -
Late style vw throw out bearings are a must to replace when seperating the motor from the trans. When inspecting your old bearing, make sure to check out how it attaches to the throw out arm. Late style bearings have clips that are built into the bearing and the ears on both sides are flat. These are also aligned on the pressure plate with a tube that is bolted to the back of the bellhousing that allows the throw out bearing to glide back and forth on. Also if your pressure plate has a ring in the center of it then this isn't the correct bearing and you will need to get a early style. Since parts can be interchanged between both swing axle and IRS transmissions it is very important that you look at this before ordering. We cannot always be 100% accurate based on transmission types alone when ordering.
Bus Type 2: 70-75
Transmission Type: IRS -
PREMIUM VERSION
SACHS BRAND
Late style vw throw out bearings are a must to replace when seperating the motor from the trans. When inspecting your old bearing, make sure to check out how it attaches to the throw out arm. Late style bearings have clips that are built into the bearing and the ears on both sides are flat. These are also aligned on the pressure plate with a tube that is bolted to the back of the bellhousing that allows the throw out bearing to glide back and forth on. Also if your pressure plate has a ring in the center of it then this isn't the correct bearing and you will need to get a early style. Since parts can be interchanged between both swing axle and IRS transmissions it is very important that you look at this before ordering. We cannot always be 100% accurate based on transmission types alone when ordering
Transmission Type: IRS -
Heavy duty spring loaded throw out bearing clips for swing axle and early irs transmissions.
111-141-177AS -
This operating shaft sleeve for aircooled VW transmissions is bolted on the bell housing of IRS transmissions. This sleeve aligns the throw out bearing with the pressure plate. If your pressure plate has a ring in the center of it, then either you cannot use this or you will need to to replace your pressure plate because you have a mix match of years. Look at the throw out bearing and shaft to help decide if this is setup for late or early style.
Bus Type 2: 71-79
Ghia: 71-79