SAND SEALED SWITCHS for Type II Bus Bus 1977

ON/OFF Sealed toggle switches feature dust and water resistant construction. Special rubber boot over toggle lever keeps out dirt and moisture. The body is also injection molded to seal out water. Heavy duty 20 amp performance

Sealed toggle switches feature dust and water resistant construction. Special rubber boot over toggle lever keeps out dirt and moisture. Heavy duty 20 amp performance

Momentary on feature provides a spring back position to be used for a starter. Sealed toggle switches feature dust and water resistant construction. Special rubber boot over toggle lever keeps out dirt and moisture. Heavy duty 20 amp performance
NOTE: If using as a starter button, use a relay on the starter wire.

Spring loaded button is ideally suited for use as a starter or horn button. Comes complete with dust boot to insure proper operation

EMPI's Universal Ignition Switch comes with 2 keys and can be used any 6 or 12 volt application. The universal ignition switch installs through a dash panel or mounting tab, etc and secures with a knurled nut. The 4 position ignition switch (accessory-off-on-start) has threaded wire posts on the back side that are labeled for the battery, ignition and accessory positions. The starter post is at the center and is not labeled.

When spliced into the positive battery cable this heavy duty switch positively shuts off all electrical current. Rated at 175 amps continuous

Turn signal switch has chrome plated housing & arm, includes emergency flasher switch. For 6 or 12 volt systems

Designed with the racer in mind, panels feature well marked switches and indicator lights. Units are completely wired for easy installation and include detailed instructions.

Designed with the racer in mind, panels feature well marked switches and indicator lights. Units are completely wired for easy installation and include detailed instructions.

Designed with the racer in mind, panels feature well marked switches and indicator lights. Units are completely wired for easy installation and include detailed instructions.

Compact three switch panel has sealed weatherproof toggle switches for use in open cockpit vehicles or when exposed to harsh conditions. Panel measures 2-1/2 In tall x 4-5/8 In wide and includes one momentary start switch, one ignition switch and one accessory switch. Switches are rated up to 20 amps and each circuit includes 60 In of 14AWG wire for easy connections.

Universal 4 In x 7 In switch panel includes one momentary start switch, one fused ignition switch and four fused accessory switches. Ideal for many motorsports applications, this panel features separately fused and switched circuits for a variety of uses including electric fuel pumps, water pumps, cooling fans, brake duct fans, and lighting. Individual circuits are rated up to 20 amps and include pre-terminated pigtails for easy connection.

Shut down the electrical and charging system with a quick twist of the knob. Switches are available with brightly screen printed aluminum mounting panel, or on/off decal for mounting through body panel.

Designed with the racer in mind, panels feature well marked switches and indicator lights. Units are completely wired for easy installation and include detailed instructions.

Designed with the racer in mind, panels feature well marked switches and indicator lights. Units are completely wired for easy installation and include detailed instructions.

Quickcar 50-520 Toggle Switch With Flip Cover This QuickCar Toggle Switch is a Heavy Duty Model and comes with a Flip-Up Cover. For use with 12 Volt systems. Designed to fit 1/2 In I.D. mounting Hole. Sold each.

Rocker Switch - On / Off - 12V - Plastic - Black - Each

Rocker Switch - On / Off / Momentary - 12V - Plastic - Black - Each

Toggle Switch - Magneto - On / Off - Double Pole - 25 amp - 12V - Each

Quickcar 50-420 On-On Crossover Toggle Switch-6 post This QuickCar Toggle Switch is for use with Dual Ignition Crossovers, switching between a cranktrigger and distributor, or reverse polarity applications. On-On type switch features a Waterproof design. Switch is made from high-quality Aircraft Grade material. Switch will fit a 1/2 In I.D. Mounting Hole and has 6 screws on the back. Sold each.

Toggle Switch - Magneto - On / Off - Weatherproof - Double Pole - 25 amp - 12V - Each

Rocker Switch - On / Off - 12V - Red Lighted - Plastic - Black - Each

Quickcar 50-522 Toggle Switch With Black Boot This QuickCar Toggle Switch is a Heavy Duty Single Pole Model and comes with a Black Rubber Cover. For use with 12 Volt systems. Designed to fit 1/2 In I.D. mounting Hole. Sold each.

Rocker Switch - On / Off - 12V - Blue Lighted - Plastic - Black - Each

Push Button Switch - Starter - Momentary - 35 amp - 12V - Panel Included - Each

Quickcar 50-512 Momentary Toggle Switch QuickCar s Momentary Toggle Switch is designed for #6 ring terminals. Fits in 1/2 In I.D. mounting hole and is rated for 25 amps at 12V.

Quickcar 50-505 Toggle Switch Bridged Double Pole This QuickCar toggle switch is an on/off double pole with bridges connecting the (2) top poles together and (2) bottom poles together. Works well for 12 volt electrical systems. Designed to fit into a 1/2 In I.D. mounting hole. Sold Each.

Quickcar 50-501 Flip Switch Guard This QuickCar Flip Switch Guard is designed to Fit 1/2 In O.D. toggle switches. Easy to see red color, prevents accidental switching on of an electrical component.

Quickcar 50-524 Red Toggle Extensions Sold as a pair, QuickCar s Toggle Switch extensions simply slide onto any of QuickCar s toggle switches. These extend the end if a toggle switch 1-1/4 In when installed.

Quickcar 50-400 Momentary Weatherproof Toggle Switch QuickCar s Weatherproof Momentary Toggle Switch is commonly used as a start switch. Internally sealed, this momentary switch is perfect to meet any high performance vehicle needs. Fits a 1/2 In I.D. mounting hole.

Quickcar 50-401 Momentary on-off-on Weatherproof Toggle Switch This QuickCar Toggle Switch has 3 positions (up: momentary-on / middle: off / down: momentary-on) and a Waterproof design. Designed for use with 12 Volt systems. Switch will fit a 1/2 In I.D. Mounting Hole.

Quickcar 50-417 On-On Single Pole Toggle Switch is QuickCar Micro Toggle Switch is for use with Dual Ignition Crossovers and is a On/On type. Features a Waterproof design. Switch is made from high-quality Aircraft Grade material. Switch will fit a 1/2 In I.D. Mounting Hole and has 3 screws on the back. Sold each.

Quickcar 57-704 8 AWG Cable Quick Disconnect This QuickCar Battery Quick Disconnect is designed to Fit 8 AWG Cable. Sold Individually, one gray holster with 2 pins, great for battery charging plugs.

Quickcar 50-415 On-Off-On Switch This QuickCar Micro Toggle Switch is a On/Off/On type. Features a Waterproof design. Switch is made from high-quality Aircraft Grade material. Switch will fit a 1/2 In I.D. Mounting Hole. Sold each.

Quickcar 50-506 Ignition & Start Switch QuickCar s In all in one In ignition switch offers the ability to supply power to an ignition system and a momentary position to start the car. Fits in a 1/2 In I.D. hole and is rated for 25 amps at 12V. Direct replacement for QuickCar Ignition/Start Kit #50-507.

Quickcar 611-096 611-6002 Remote Switch and Plate 3 position momentary/off/momentary with mounting plate. Used for the remote recall and memory clearing of QuickCar s 3 In analog tachometer (Pt.# 611-6002)

Rocker Switch - On / Off - 12V - Green Lighted - Plastic - Black - Each

Rocker Switch - On / Off / On - 12V - Red Lighted - Plastic - Black - Each

Rocker Switch - Momentary - 12V - Plastic - Black - Each

Quickcar 50-402 Momentary On-Off-On Reverse Polarity Switch This weatherproof QuickCar toggle switch is perfect for any application that requires a 2-way electric motor. Generally used as a Micro Sprint/Mini Sprint car wing switch, it has 6 posts to connect power/ground coming into the switch and additional posts for outgoing power/ground. Internally sealed to the elements, this switch fits a 1/2 In hole and includes mounting nuts and lock washers.

Quickcar 57-706 4 AWG Cable Quick Disconnect This QuickCar Battery Quick Disconnect is designed to Fit 4 AWG Cable. The battery cable quick disconnect enables you to change out a battery fast. It is also used for battery changing and anywhere a quick disconnect is helpful. Sold Individually, one gray holster with 2 pins.

Quickcar 57-705 Cable Quick Disconnect 2 Gauge This QuickCar Battery Quick Disconnect is designed to Fit 2 AWG Cable. The battery cable quick disconnect enables you to change out a battery fast. It is also used for battery changing and anywhere a quick disconnect is helpful. Sold Individually, includes one gray holster and 2 pins.

Quickcar 50-434 Remote Starter Button This QuickCar Remote Start Button will make jobs like setting valves much easier! Heavy duty gator clamps are run to the starter solenoid so engine can be rolled over easily without reaching into the cockpit.

Quickcar 52-515 On/Off/On Rocker Switch QuickCar s Premium Rocker Switch is Rated for 25-amps at 12V. Sold Individually.

Quickcar 50-610 Boot for Toggle Switch This boot is designed for QuickCar s standard toggle switches to help prevent water or other cleaning chemicals from getting into the switch. Sold individually, black boot is elastic/flexible so it will not tear as the switch is flipped over it s life.

Quickcar 50-504 Three Wheel Brake Switch This QuickCar Brake Cut-Off Switch comes with a cover. Switch comes with spade connectors on the back instead of standard type screws. This unit is commonly used on Dirt race cars for the 3 wheel brake switch. Sold Each.

Quickcar 50-500 Toggle Switch Single Pole This QuickCar Toggle Switch is a Standard Single Pole Type. Designed for use with 12 Volt systems. Designed to Fit 1/2 In I.D. Mounting Hole. Sold each.

Quickcar 50-526 Black Toggle Extensions Sold as a pair, QuickCar s Toggle Switch extensions simply slide onto any of QuickCar s toggle switches. These extend the end if a toggle switch 1-1/4 In when installed.

Toggle Switch - On / Off - Single Pole - 25 amp - 12V - Long Switch - Each

Rocker Switch - On / Off - 12V - Amber Lighted - Plastic - Black - Each

Quickcar 50-410 Weatherproof Single Pole Toggle Switch This QuickCar weatherproof toggle switch is a single pole on/off type. Internally sealed, this switch is perfect for controlling an ignition system or accessory that may be in a high performance vehicle. Switch is made from high-quality Aircraft Grade material and fits a 1/2 In I.D. Mounting Hole.