STEERING SHAFT MOUNTS for Type II Bus Bus 1977

Billet steering bearing housing. 4 inch long. Clamps on 1-1/2 inches tube. Brass bushing for steering shaft. Nice easy way to setup your steering.
Mounts a 3/4 inches steering shaft
Length: 4 inches
Width: 2-1/2 inches

Billet steering bearing housing. 4 inch long. Clamps on 1-1/2 inches tube. Brass bushing for steering shaft. Nice easy way to setup your steering.
Mounts a 7/8 inches shaft.
Width: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.
Heavy duty construction with brass bushing.
Fits a 3/4 inches Steering Shaft
Length: 5.144 inches
Width: 4.5 inches
Height: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.
Needle bearing instead of brass, with seal.
Fits a 3/4 inches Steering shaft
Welding is required
Height: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.
Heavy duty construction with brass bushing for steering shaft.
Fits a 7/8 inches Steering Shaft.
Height: 2 inches

Weld on steering shaft mount. Mount is setup to be installed on a 1-1/2 inches windshield bar.
Needle bearing with seal. Heavy duty construction.
Fits a 7/8 inches Steering Shaft
Length: 5.144
Width: 4.5
Height: 2 inches

Tilt steering assembly allows easy access to tight driver seats. Welds to 1-1/2 inches tubing. Uses a 3/4 inches steering shaft