TRAILING ARM BEARINGS & SEALS for Type II Bus Bus 1979

Application year: 54,55,56,57,58,59,60,61,62,63,64,65,66,67,68...

Inner diameter: 1.182 inches
Outer diameter: 2.834 inches
Thickness: .748 inches

This is the inner bearing on a vw IRS rear trailing arm. This is put in from the CV side. If you hear a lot of clunking or ticking, it is time to replace. These take a lot of abuse expecially in a offroad situation.

Sold Each

OEM NUMBER
113-501-283

Inner diameter: 1.182 inches
Outer diameter: 2.440 inches
Thickness: .630 inches

Beetle Type 1: 69-79
Ghia: 69-74
Type 3: 69-74

This is the outer bearing inside a vw IRS trailing arm. These take a big beating so replace them whenever you change stubs.

Sold Each

Inner diameter: 1.182 inches
Outer diameter: 2.440 inches
Thickness: .630 inches

Beetle Type 1: 69-79
Ghia: 69-74
Type 3: 69-74

PREMIUM VERSION
SKF BRAND

This is the outer bearing inside a vw IRS trailing arm. These take a big beating so replace them whenever you change stubs.

Sold Each

Inner diameter: 1.182 inches
Outer diameter: 2.440 inches
Thickness: .630 inches

Beetle Type 1: 69-79
Ghia: 69-74
Type 3: 69-74

Replacement rear axle seal for all type- 1 applications. These go both on the inside of the trailing arm by the cv joint and also on the outside under the 4 bolt bearing cap.

This works on both IRS and swing axle transmssions.

Swing axles only need 1 per side but IRS will require 2

Beetle Type 1: 46-79
Bus Type 2: 50-67
Ghia: 56-74

Replacement seal kit kit. This kit will work for both IRS and Swing Axles applications. A must if replacing bearings or installing disc brakes. Keep the oil from running into the brake drum on swing axles and keep out the dirt

Beetle Type 1: 46-79
Bus Type 2: 50-67
Ghia: 56-74

IRS bearing housing clip to snap your bearings into place. This goes on the CV joint side of the arm and is snapped into the bearing carrier. This is often times not needed as the stub pinches the bearings into place.

Sold Each

Beetle Type 1: 69-79
Ghia: 69-74
Type 3: 69-74

Replacement outer type 2 axle seal. This seal will go next to the wheel bearing and behind the 4 bolt cap that holds either the backing plate on or caliper bracket

Bus Type 2: 68-79
Vanagon: 80-82
Quantity: Sold Each.

Replacement wheel bearing for the rear of your Type 2 Bus 71-79

Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 50-67

Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 68-79

Inner
Sold Each

Replacement wheel bearing for the rear of your Type 2 Bus 63.70

Sold Each